Catalogue
          
           
 
TPC-046
 RS-485/422 Protocol Converter
          
             
 
tpc_big
          
 
     
  Specifications:  
     
  — Converts American Dynamics' Dome control protocol AD RS-422/RS-485 to any of the following systems:
           Pelco D
           JVC
           Panasonic
           VCL
           Pan & Tilt  TMI-04C controller. (Proprietary interface).
— Fujitsu MB90F543 microprocessor with 256 Kbytes of Flash; This memory allows five additional protocol implementation under demand.
— Two full-duplex RS-422/485 ports with protections.
— Power supply: 9-24 V AC/DC		  
  — More details  
     
 
UP
Order:      
email
RETURN  
         
               
 
TBR-FDS-2002
 Development board for LX16 Fujitsu microcontroller
          
             
 
         
 
     
   Specifications:  
 
— Fujitsu MB90F543 microprocessor with 256 Kbytes of Flash memory for program, 12 Kbytes of RAM and 2 integrated CAN controllers besides the rest of usual peripherals.
— Two CAN drivers Phillips PCA82C251.
— Two RS232 port interfaces, one for debugging and program downloading, and the other for user applications.

— Two crystal oscillators: the master oscillator running at 4 Mhz (the microcontroler has an internal multiplier that quadruples the input, resulting a fetch code 62,5 ns long) and the real time oscillator running at 32 Khz, useful if saving power operating modes are desired.
— Female pins and pull-up resistors are included on every I/O port to make user work easier, with the posibility to connect them to +VDC or ground by selection jumpers.
— 8 LEDs with limiting resistors for debugging purposes.
— Reset button.
— 5.08mm standard terminals for supply and CAN buses connection.
— Two DB-25 female connectors for both RS-232 serial ports.
  — 100x160 mm size, 1.6 mm thickness, two sided fiber glass Printed Circuit Board.  
— User manual and some examples are included.
UP
Order:     
  RETURN  
         
              
 
TBR-CR-2001
Temperature and humidity controller board
          
 
         
 
         
 
   Specifications:  
     
— Motorola 68HC11F1 microproccesor in expanded mode with 64Kb external EPROM program memory, 1Kb RAM and 256 bytes EEPROM for calibration data.
— 16 Mhz cristal oscillator.
— External input for temperature sensor. The circuitry is designed to admit resistive sensor with 0.00385 ohm/ohm/ºC Temp.Coeff (not supplied).
— External input for humidity sensor Honeywell HiH3605A (not supplied).
— IDC connector for LCD display HD44780 or equivalent.
— IDC connector for external matrix keyboard.
— Batery for date/time keeping in power supply absence.
— Solid state relay output for temperature control allowing 5A and 250 VAC.
— One DPDT relay (two circuits, two taps), with jumpers to configure the output circuit.
— Four additional open collector outputs with 500 mA drain capability in active state.
— 100x160 mm size, 1.6 mm thickness, two sided fiber glass Printed Circuit Board.
— 5.08mm standard terminals for input/output signal connection.
  — User manual and application program are included.  
UP
Order:     
RETURN
         
            jltebar jltebar jltebar